AGA GC 3 GC 3 Manuale di Servizio

03/10 EINS 515932PLEASE READ THESE INSTRUCTIONS BEFORE INSTALLING THIS APPLIANCEREMEMBER: when replacing a part on this appliance, use only spare part

SEE FIG. 2NOTE: Prior to assembly remove controls mounting bracket from burner housing.1. Fit gas cock to inlet supply pipe.2. Fit burner assembly to

11Fig. 5TO TEST THE AIMS CONTROL HANDSETHandset to Base Unit Signal Check/Language SelectionComplete the following procedure to check the handset is c

CAUTION: BEFORE LIGHTING: ENSURE KNOB (A) IS IN THE OFF POSITION (SEE FIG. 8).ALSO ENSURE GAS SUPPLY TO COOKER IS ON, AND THE GAS SERVICE COCK (C) ISI

13COMMISSIONING (CONTINUED)7. Check burner pressure as follows:-Repeat instruction 6 on completely cold cooker with the pressure gauge fitted to the b

BURNER CONTROLS14DESN 513393Fig. 7Fig. 8 Fig. 9Fig. 10Fig. 11Fig. 12Fig. 13

15

16For further advice or information contactyour local AGA SpecialistWith AGA’s policy of continuous productimprovement, the Company reserves the right

SECTION PAGEHEALTH AND SAFETY 3INSTALLATION 4LOCATION 4TECHNICAL DATA - AGA GC3 5TECHNICAL DATA - AGA GC3 (WITH MODULE) GC3M) 6TECHNICAL DATA (CONTINU

Consumer ProtectionAs responsible manufacturers we take care to make sure that our products are designed andconstructed to meet the required safety st

With specific exceptions, the installing of any type of AGA cooker is subject to the respectivedirections contained in current issue of The Building R

5TECHNICAL DATA - AGA GC3Fig. 1 DESN 512841 BPLEASE NOTE: SIDE CLEARANCE W IS ALSO REQUIRED ON THE LH SIDE FOR THEBAKING OVEN DOOR.COOKER DIMENSIONSWh

6TECHNICAL DATA - 3 OVEN AGA WITH MODULE (GC3M)Fig. 1A - Gas Supply Connections (Approximate Positions)NOTE: 1/4” BSP to 15mm fitting provided.DESN 51

NATURAL G20MAXIMUM HEAT INPUT 4.4 kWThermostat Bypass Size 110Main Burner Injector 400Pilot Injector 7218Inlet Pressure (EU COUNTRIES ONLY) 20mbarBurn

8INSTALLATION PIPESInstallation pipes should be fitted in accordance with current Gas Regulations. Pipework from themeter to the cooker must be of ade

BURNER ASSEMBLY - AIMS CONTROLWIRING DIAGRAM9Fig. 2 DESN 515489Fig. 3 DESN 515479A - ON/OFF CONTROL KNOBB - TEMPERATURE CONTROL KNOBC - GAS COCKD - IN